How To Scan For Repeater Tones Or Privacy Codes On Baofeng UV-5R radio?

To scan for repeater tones or privacy codes on a Baofeng UV-5R radio, you can follow these steps:

  1. Turn on the radio by pressing and holding the orange button on the top right-hand side of the radio.
  2. Press the VFO/MR button on the left-hand side of the radio to switch to the VFO (Frequency) mode.
  3. Enter the frequency of the repeater you wish to use by using the keypad or the up/down arrow keys.
  4. Press the menu button (the one with the letters “MENU” on it) on the right-hand side of the radio.
  5. Use the up/down arrow keys to scroll through the menu options until you see “T-CTCS” or “T-DCS”, depending on the type of tone you are looking for.
  6. Press the menu button again to enter the tone menu.
  7. Use the up/down arrow keys to scroll through the tone options until you find the tone you are looking for. Note that the tones may be labeled with a number or a letter, depending on the tone type.
  8. Press the menu button again to exit the tone menu.
  9. Press the scan button on the left-hand side of the radio to start scanning for the tone or code.
  10. If the radio detects the tone or code, it will stop scanning and you will hear the repeater transmission.
  11. To exit the scan mode, press the scan button again.

Note that the exact steps may vary slightly depending on the specific model of the Baofeng UV-5R radio you have.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top